7. Carefully insert the elevator into the
fuselage, noting that the elevator needs to be
upside down and back-to-front when inserted.
Once it is fully inserted, you can flflip it over.
8. Carefully insert the horizontal stabiliser into
the fuselage. Insert the elevator hinges into
the horizontal stabiliser. Measure to ensure
that the horizontal stabiliser is evenly spaced
on both sides of the fuselage.
9. Measure to ensure that the distance on
both sides between the main wing and the
horizontal stabiliser is the same. Ensure
that the horizontal stabiliser remains evenly
spaced on both sides of the fuselage.
10. Ensure that the horizontal stabiliser and
the main wing are parallel to each other
and are at right angles (90 degrees) to
the fuselage. Use wedges if required.
11. Ensure that the main wing is correctly
located and use thin CA glue to attach the
wing to the fuselage.
Note: Do not use too much thin CA glue, as
it might eat the polystyrene wing core.
12. Use a suitable foam glue to reinforce
the wing to fuselage join on both sides top
and bottom.
To Next Page
Loading...