13. Use a small amount of thin CA glue to
attach the horizontal stabiliser to the fuselage.
Note: Do not use too much thin CA glue, as it
might eat the Depron foam core.
14. Use a suitable foam glue to reinforce the
horizontal stabiliser to fuselage join on both
sides top and bottom.
15. Adjust the elevator so there is a hinge gap
of about 1mm and it is evenly spaced on both
sides of the fuselage.
Use thin CA glue to attach the elevator hinges
to the horizontal stabiliser hinge slots.
16. Use thin CA glue to attach the aileron
and rudder control horns.
Install the control horn plate on the other
side of the rudder.
17. Use thin CA glue to attach the elevator
control horn.
Install the control horn plate on the other
side of the elevator.
18. Install the tail wheel as shown, ensuring
that the tail wheel wood bracket can rotate
on the wire.
To Next Page
Loading...