25. Install the motor using 4 wood screws.
Ensure the motor rotates smoothly.
26. Install the electronic speed
controller (ESC). Connect the motor to the
speed controller.
28. Cut 8 pieces of heat shrink tubing of
length 12mm. 2 pieces of heat shrink are
required for each pushrod to attach a wire
z-bend (see step 29).
27. Install the EZ connectors on to your
servo arms.
29. Place a wire z-bend under the heat shrink
tubing on a carbon fifibre pushrod. Heat the
heat shrink until it shrinks and then use thin
CA to glue the wire z-bend, heat shrink tubing
and carbon fifibre pushrod together.
30. Install a receiver. Connect all 4 servos
and the ESC to the receiver. Turn on your
radio and attach a battery to the ESC.
To Next Page
Loading...