31. Confifigure each aileron as shown. With the
control surface in the neutral position and the
servo arm at 90 degrees to the pushrod,
tighten the EZ Connector grub screw to lock
the pushrod in place.
32. Confifigure the rudder as shown.
33. Confifigure the elevator as shown.
34. Locate the landing gear pieces as shown.
35. Install the wheel and wheel cover as shown.
36. Install the landing gear decorative fifilm
using a suitable foam glue. Use clips to hold
them in place until the glue is completely dry
and then remove the clips.
To Next Page
Loading...