Futurmat F3 - FUTURMAT Site Ready Checklist; Bench Space and Machine Fitment Confirmation; Power and Water Site Preparation Verification; Site Accessibility and Operational Readiness

Site Ready Checklist for the F3
 Please complete form below. If cancellation occurs without 24-hours notice or a technician has to return due to site not
being ready, additional service charges will apply. Please contact GCS if you have any queries 1300 552 883.
INSTALLATION WILL NOT TAKE PLACE UNTIL THIS CONFIRMATIN FORM HAS BEEN EMAILED OR FAXED BACK TO
GLOBAL COFFEE SOLUTIONS- email sales@globalcoffee.com.au or 02 4284 6099
Customer Name: ........................................................................................................................................................
Store Address: ............................................................................................................................................................
Bench Space for:
Futurmat F3 3 Group -460h x 570d x 940w mm
Futurmat F3 2 Group - 460h x 570d x 770w mm
Macap M7 Range of grinder - 635h x 360d x 250w mm
3 Group F3 – 20 Amp single phase wall outlet within 1 mtr of machine
2 Group F3 – 15 Amp single phase wall outlet within 1 mtr of machine
10 Amp single phase wall outlet/s within 1 mtr of machine per grinder
3/8 Cold Water Male stop tap within 1 mtr of machine
Drainage within 1 mtr of machine – open tundish or s bend
60mm hole in the bench where machine is located
Internal cupboard holes drilled [if cabling requires travelling through]
Accessibility:
Store Owner’s Name: ..............................................................
Signature: ...............................................................................
Date: ......................................................................................
Stairs – Yes/No – If yes how many:
Parking available on site
Consumables Available at time of install – Yes/ No
Staff Must Be Available for training at completion of the installation – Yes/No
Additional Notes:
By faxing back this Order Confirmation form the
customer is confirming that there is sufficient
power and space to install the machine. Should
this not be the case, upon installation the
customer will be charged for all service fees
incurred.