FUXTEC FX-EB152 - Cold Start of the Engine

To Next Page

To Previous Page

Original User Manual FUXTEC FX-EB152/FX-EB162_de_en_fr_rev15

27. Cold start of the device

1. Place the device on a firm and flat surface.

Slide the engine stop switch to the start position "1".

2. Move the choke lever upwards to "COLD START."

3. Press the carburetor pump about 8-10 times (until petrol flows in the line)

4. Pull out the starter rope with a short-stroke until resistance is felt

(about 100mm). A continuous high-speed train will provide a strong spark and start

the engine

5. Then set the choke lever to the "WARM START" position

6. Let the engine warm-up at idle for about 10 minutes.