Original User Manual FUXTEC FX-MT152/-MT152E/-MT252_rev16
39
Starting/stopping the device
Cold start
1. Place the device on a firm and flat surface.
Slide the engine stop switch to '' I '' in the direction of the engine.
2. Move the choke lever upwards to "COLD START."
3. Press the carburetor pump about 8-10 times (until gasoline flows in the line)
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, mainly fast train will provide a strong spark and let the
engine report.
5. Important: As soon as the engine has responded, set the choke lever to the "WARM
START" position and pull the starter immediately until the engine starts.
6. Let the engine warm-up at idle for about 10 minutes
NOTE: If the device does not start after repeated attempts, refer to troubleshooting
To Next Page
Loading...
