[ ]F2.7 Two Speed Feed Enable
[ ]F2.8 Sequential Feed Enable
[ ]F2.9 Invert Relays Enable
[ ]F2.A Parallel Feed Enable
*[ ]F2.B
*[ ]F2.C
*[ ]F2.D
[ ]F3.0 Baud Rate Selection
[ ]F3.1 Parity Selection
[ ]F3.2 Checksum Transit Enable
[ ]F3.3 Delay After CR-LF
[ ]F3.4 CN Print Enable
[ ]F3.5 ID Print Enable
[ ]F3.6 Negative Print Enable
[ ]F3.7 24 Hour Clock Enable
[ ]F3.8 Preamble
[ ],[ ],[ ]
Postamble
[ ],[ ].[ ]
Custom formatting - use chart
[ ]F4.0 Print Mode
[ ]F4.1 Continuous Data Format
[ ]F4.2 Weight Change Percentage
To Next Page
Loading...