[ ]F6.2 Decimal Position
[ ]F6.3 Enter CAL Mode
[ ]F6.4 Linearity Factor
*[ ]F7.0
*[ ]F7.1
*[ ]F7.2
*[ ]F7.3
*[ ]F7.4
*[ ]F7.5
*[ ]F7.6
*[ ]F7.7
*[ ]F7.8
*[ ]F7.9
*[ ]F7.A
*[ ]F7.B
*[ ]F7.C
* only used in custom applications
The following section describes the convention used by the DWM-IV to
communicate with a user-supplied computer or terminal. Data is transmitted as:
one start bit, seven or eight data bits, one even, odd, or no parity bit, and two stop
bits for a total of 11, 12 or 13 bits per character. The BAUD rate, parity and serial
communications enable must be configured while in the SET-UP procedure using
F3.0, F3.1, F4.4.
Serial Bi-Directional Communications
All functions accessible from the front panel may also be accessed using a remote
communication link. The following table describes the ASCII codes to be
transmitted to the DWM-IV which represent the front panel buttons:
To Next Page
Loading...