3
FWE MOBILE HUMI-TEMP HEATED HOLDING CABINETS
SERIAL AND MODEL NUMBER
INSTALLATION AND CLEANING
UNPACKING
These numbers are found on the nameplate (serial tag) affixed
near the electrical cord portal. Please record them in this
booklet, in the space provided on page 5. When ordering
parts and/or service, you will need to provide this information.
The voltage and amperage of the unit are also stamped
on the serial tag.
After uncrating your cabinet, remove all tape and padding
which held all doors, shelves, racks, cord, etc., in place during
shipment.
Keep your cabinet clean by simply wiping the interior and
exterior, as needed, with a damp cloth or sponge and a
mild soapy solution.
NEVER USE ABRASIVES, ACIDS, OR
STRONG CLEANERS.
Do not flood or allow electrical parts to become wet.
The interior tray slide assemblies and humidifier pans
are removable for easy cleaning. A stainless steel
cleaner/polish is recommended for the exterior to
maintain a "like-new" appearance.
DO NOT USE WAX OR STRONG CLEANERS ON
DOOR GASKETS OR VINYL TRIM.
CLEANING
To Next Page
Loading...
