33
Check the secure fastening of the front and rear wheels.
Always maintain the ride-on mower and the attachments in perfect operating condition.
All safety devices must be present and be in perfect operating condition.
Ensure that the tyres have the correct tyre pressures. The tyre pressures specified in
the instruction manual must not be exceeded.
Only perform work on the cutting unit when wearing thick work gloves and exercising
extreme care.
Check the function of the brakes at regular, short intervals and, if necessary, have the
required adjustments or maintenance operations performed by a technician.
WARNING
Never work on or touch conducting parts on the ignition unit with the engine running.
Always pull the spark plug boot from the spark plug before starting any work of care or
maintenance. Never perform any work on the machine while it is running. Any work not
described in these Operating Instructions must be performed by an authorized service
workshop only.
Wheel axles and wheel hubs
These should be lightly greased once a season.
Blade
For safety reasons you should only ever have your blade sharpened, balanced and
mounted by an authorized service workshop. For optimum results it is recommended
that the blade should be inspected once a year.
Change the blade.
When changing the cutting tool, only use original replacement parts. Wear gloves to
avoid cut injuries while changing the blade. Never install another blade.
• Remove the ignition key.
• Remove the screw to replace the blade.
• Install everything as described in fig. Fasten the screw correctly. The fastening torque
in 65 Nm. Replace the screw and washer, as well, if you replace the knife.
Checking the oil level
CAUTION! Never run the engine with no or too little oil. This could cause severe
damage to the engine. Use only SAE30 engine oil.
• Position the lawnmower on a straight, level surface.
• Remove the ignition key (12) • Remove the oil dipstick (20) by turning it to the left,
then wipe off he dipstick.
To Next Page
Loading...
