34
• Screw in the dipstick up to the limit stop again in the lling nozzle.
• Pull out the dipstick and read the oil level horizontally. The oil level must be positioned
between the max and min of the oil dipstick (20).
Oil change
• The motor oil change should be completed annually before the start of the season
while the motor is at operating temperature and shut off.
• Only use motor oil (SAE 30).
• Position the lawnmower on a straight, level surface.
• Remove the ignition key (10)
• Clean the area around the oil dipstick.
• Slowly unscrew and remove the oil dipstick.
• Place an oil pan (or suitable container) under the oil drain bolt.
• Remove the oil drain bolt and allow the oil to drain.
• After the oil has drained completely, suggest replacing the oil drain bolt.
• Refill the oil as described.
• Replace the oil dipstick and hand-tighten.
• Clean up any spilled oil.
• Dispose of the used oil in accordance with applicable regulations.
Air filter maintenance
Fouled air filters (19) diminish the motor performance due to reduced air supply to the
carburetor. Regular inspection is therefore essential. The air filter should be checked
every 50 operating hours and cleaned as required. The air filter must be checked more
To Next Page
Loading...
