10
Make sure the battery pack snaps into place and that
battery pack is secured in the tool before beginning
operation. Improper installation of the battery pack can
c
ause damage to internal components.
R
EMOVING THE BATTERY PACK
L
ocate the battery release catch on the top of the
b
attery and press downwards, Fig 6. Whilst holding
down the battery release catch slide the battery pack
a
way from the tool.
OPERATION
STARTING/STOPPING THE BLOWER (FIG.7)
To start the blower, place the On/Off switch in the ON
( l ) position.
To stop the blower, place the On/Off switch in the OFF
(O) position.
OPERATING THE BLOWER
Warning! Battery tools are always in operating
condition. Therefore, switch should always be in the
OFF position when not in use or carrying at your side.
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when
water is available.
Conserve water by using power blowers instead of
hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
After using blowers or other equipment, clean up!
Dispose of debris properly.
MAINTENANCE
Warning! When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage.
Warning! Always wear safety goggles or safety glasses
with side shields during power tool operation or when
blowing dust. If operation is dusty, also wear a dust
mask.
Warning! To avoid serious personal injury, always
remove the battery pack from the product when
cleaning or performing any maintenance.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
Warning! Do not at any time let brake fluids, gasoline,
petroleum- based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
d
amage, weaken or destroy plastic which may result in
serious personal injury.
O
nly the parts shown on the parts list are intended to
b
e repaired or replaced by the customer. All other
parts should be replaced at an Authorised Service
C
enter.
STORAGE
C
lean all foreign material from the blower.
Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
TECHNICAL SPECIFICATION
Voltage 18V DC
Air velocity 60m/s
Air volume 3 m
3
/min
Sound Pressure Level L
p
A
69.5 dB(A)
K=3dB(A)
Sound Power Level L
WA
78.2 dB(A)
K=3dB(A)
Vibration Level 0.941 m/s
2
, K=1.5m/s
2
To Next Page
Loading...
