8
Do not operate this unit when you are tired, ill or
under the influence of alcohol, drugs or medication.
Never operate a machine that has been modified from
its original specification.
Always maintain the machine in good working order.
Have it regularly serviced by an authorised service
agent.
Do not operate the unit without being completely
familiar on all safety aspects and functions especially
how to stop the machine in an emergency.
Never use the blower if the stop switch is faulty or not
functional.
Prior to each use inspect the machine for damage.
Ensure all safety features and mechanisms function
correctly.
Always stop the machine when not in use, checking
parts, maintaining or working on the machine.
Always ensure all handles and guards are fitted when
using the machine. Never attempt to use an
incomplete machine or one fitted with an unauthorised
modification.
Always be aware of your surroundings and stay alert
for possible hazards that you may not hear due to the
noise of the machine.
Do not point the blower nozzle in the direction of
people or pets.
Take care when operating as loose debris or stones
may be thrown up, possibly damaging property.
Do not operate in poor lighting.
Keep all parts of your body away from any moving
parts and all hot surfaces of the unit.
Wear a face filter mask in dusty conditions to reduce
the risk of injury associated with the inhalation of dust.
Check the work area before each use. Remove all
objects such as rocks, broken glass, nails, wire or
string which can be thrown or become entangled in
the machine.
Ensure the handles remain clean and free from oil, fuel
and moisture.
Only use replacement parts supplied by the
manufacturer.
All safety devices must remain fitted, functioning and
where possible serviced.
Avoid accidental starting. Be sure the power switch is
not on before plugging in. Turn off power switch
before unplugging.
Do not use tool if switch does not turn it on or off. Any
tool that cannot be controlled with the switch is
dangerous and must be repaired.
Do not use with damaged plug. If tool is not working
as it should or has been dropped, damaged, left
outdoors, or dropped into water, return it to an
authorized service center.
Do not pull or carry by cord, use cord as a handle,
close a door on a cord, or pull cord around sharp
edges or corners. Do not run appliance over cord.
Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
Do not handle plug or appliance with wet hands.
Do not use with damaged cord or plug. If appliance is
not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, return
it to a service center.
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorized
service center to avoid risk.
Extension Cord - To reduce the risk of disconnection
of appliance cord from the extension cord during
operating, it is possible to tie the extension cord and
power cord in a knot to prevent them from becoming
disconnected during use. Make the knot as shown
below, then connect the plug end of the power cord
into the receptacle end of the extension cord. This
method can also be used to tie two extension cords
together.
Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw. A wire gauge size of at least 1.5mm
2
is
recommended for an extension cord 50 feet or less in
length. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord. An
undersized cord will cause a drop in line voltage
resulting in loss of power and overheating.
Never run the unit without the proper equipment
attached. Always ensure the blower tubes are
installed.
When not in use, blower should be stored indoors in a
dry, locked up place—out of the reach of children.
Maintain tool with care. Keep fan area clean for best
and safest performance. Follow instructions for proper
maintenance.
Do not attempt to clear clogs from tool without first
unplugging it.
To Next Page
Loading...
