Edition 09.2014 03.5.
Information in this document can be modified without notice.
Ferco Architectural Hardware Inc.
, Rue Berlier
Laval QC HL S
T ..
F ..
...
www.ferco.ca
Gripset Handle Installation Instructions_K-C/K-C_-
Gripset Handle Installation Instructions
Door Multi-point Locking System
RH = RIGHT HAND
LH = LEFT HAND
The actuator is set Right Hand (RH) in the box.
To change handing to Left Hand (LH), take out gasket, remove
four screws from actuator and turn actuator degrees to show
LH on top. Insert four screws and retighten. Reposition the gasket.
* Set as Right Hand (RH) in packaging
REVERSING THE UNIVERSAL ACTUATOR
(ON THE EXTERIOR PLATE, UNDER THE GASKET)
TOP OF PLATE
SALEM (K-C2060)
HANDLE HANDING
(VIEWED FROM OUTSIDE)
INSWING
OUTSWING
for K-C/K-C
LEFT
HAND
RIGHT
HAND
BERKELEY (K-C2070)
Inside the Box
Pos Description
Exterior handle set with
gasket and cylinder
Interior plate with knob
Interior handle
Two M x mm screws
( /'' doors), two M x
mm screws ( /'' doors),
one Allen key
Set of two keys
Bottom screw, screw washer,
screw cover
Handle nylon washer (only
supplied with Salem handle)
To Next Page
Need help?
General
