Need help?Do you have a question about the GAF Master Flow PG2 and is the answer not in the manual?
Observe safety precautions for general use, electrical, hazardous materials, and installation.
Connect to a 120V, 60Hz grounded circuit with appropriate wiring and capacity.
Ensure the fan blade is tight and the set screw is securely fastened during operation.
Interlock ventilator with gas/oil appliances to prevent simultaneous operation during heating cycles.
Verify adequate intake ventilation at soffit, undereave, and fascia areas for balanced airflow.
Place the vent behind an existing gable wall louver or install an automatic louver.
Securely fasten all four mounting brackets to the unit's shroud using bolts and nuts.
Screw or nail the unit to wall studs or wood supports via pre-punched holes in brackets.
Disconnect power before wiring; connect to thermostat and ensure proper wiring connections.
To Next Page
General