Cleaning the Selector Faucet on a Gaggia Brera
Tools Required:
#10 Torx screwdriver
3mm Allen key/wrench
Pipe cleaner/thin brush
**BEFORE BEGINNING THIS OPERATION, MAKE CERTAIN THAT THE MACHINE IS OFF,
UNPLUGGED, AND COLD**
1. Remove the brew unit from the machine. Behind it, you will see the water coupling (beige
water line connection with two red or orange o-rings).
2. Remove the Torx screws and pull down the visible portion of the valve. You will be left with this:
3. Use the same Allen key/wrench to remove the valve-insert the key into the center of the valve
To Next Page
Need help?
General
