I
FOREWORD
It is the intent of this manual to give the reader certain key points of information critical to the
proper installation of the door operator. It is not intended to give comprehensive installation
procedures nor does it cover the installation of door headers, track, hangers, etcetera.
It is hoped that the procedures presented in this manual will reduce the installation and
adjustment time and result in a smooth, long lasting door operation.
When properly installed, GAL door operators will give many years of trouble free service.
COMMENTS:
All GAL door operators are factory adjusted and tested for the actual job requirements.
When installed correctly, they may require minor adjustments to suit actual job
conditions.
IMPORTANT NOTES:
All equipment must be installed, adjusted, tested and maintained to comply with all
Federal, State/Provincial, and Local codes.
Kinetic Energy and Stall Force must be adjusted to comply with ASME, A17.1,
Rule 112.4/5, and CSA/B44, Rule 2.13.4/5.
Before mounting the operator, check that the car door is plumb, free and moves
easily without bind. Check the attached standard measurement sheets.
Install the operator according to the measurements supplied.
Contact GAL if the following label is missing from the door operator.
To Next Page
Loading...
