INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
8
To do these when the machine
is not level:
Using the spanner turn
locknut in a anticlockwise
direction. Then turn locknuts
together with adjust feet to
unscrew.
Use a spirit level to check the machine is standing level.
Hold adjust feet securely with a pipe wrench. Turn locknut again
using the spanner until it sits firmly up against the housing.
Adjustable feet
Locknuts
Loose
Locked
Low
High
NOTE
Vibration and noise may occur if the locknuts
do not sit firmly up against the houses.
Drain hose connection
1.Direct into a sink
If the outlet spigot has not been used before, remove any
blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if
required, ensure a loop is formed in the drain hose to prevent
waste from the sink entering the washing machine.
If required, the drain hose can be extended to a length of 4 m.
2. Connected securely to a standpipe
Firstly form a hook in the end of the drain hose using the “U” piece
supplied.
Place the drain hose into your standpipe, which should have an
internal diameter of approximately 30mm thus ensuring there is
an air break between the drain hose and standpipe.
When discharging into a standpipe ensure that the top fo the
standpipe is no more than 90cm and no less than 60cm above
floor level.
“U” piece
supplied
Loop
Water inlet connection
Connect the inlet hose supplied with the
machine to a tap with a 3/4" thread.
Do not use previously employed hoses.
Installation should comply with local water
authority and building regulations
requirements.
There are two inlet valve, one is connected
to a cold water supply and the other is
connected to a hot water supply. Follow the
indication of the picture below to complete
the connection.
To Next Page
Loading...
