9
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Stacking Kit
In order to stack this dryer, an Galanz stacking kit is required.
Dryer
Washer
1"
(25mm)
5"
(127mm)
2"-5"
(50mm-127mm)
1"
(25mm)
Only an Galanz
DO NOT attempt to stack this dryer on any other washer, as
damage, injury or property damage could result.
dryer can be stacked on top of This washer.
INSTALLATION INSTRUCTIONS
TOOLS AND PARTS
Installation Requirements
Gather the required tools and parts before starting installation
Tools Needed:
Flat-blade screwdriver
#2 Phillips screwdriver
Min. 8" long
screwdriver
TORX®T20®†
1/4" and 5/16" nut driver
(recommended)
Channel locks Wire stripper (direct wire
installations)
Pliers
Tape measure
Level
Utility knife
inlet valve for cold water
inlet hose for cold water with a white nut
inlet hose for hot water with a white nut
inlet valve for hot water
To Next Page
Loading...
