.08.
Owner’s Manual & Safety Instructions
Reciprocating Saw
a.Rotate the quick-release blade clamp clockwise with hand.
b.Take the saw blade out of the clamp.
c.Release the quick-release blade clamp.
Operation
Switch On/Off
a. Press the On/Off switch, and keep it pressed.
b. Push the lock-on button, and the machine will keep working.
c. To stop the machine, release the On/Off switch.
Adjusting the speed
The speed of the switched-on power tool can be
variably adjusted, depending on how far the On/Off
switch is pressed.Light pressure on the On/Off
switch results in a low rotational speed. Further
pressure on the switch results in an increase in
speed.
Adjusting Position of Adjustable footplate
According to the cutting needs, adjust the base by hand.
Cutting Methods
: The choice of saw blade is dependent on the material and the
working conditions.
Switch the machine on and guide it toward the work piece. Position the base plate
onto the surface of the work and saw through the material applying uniform con-
tact pressure and feed. After completing the working procedure, switch the ma-
chine off.
: If the saw blade should jam, switch the machine off immediate-
ly.Widen the gap somewhat with a suitable tool and pull out the machine.
General Cutting
In general, coarser blades are for wood, plastics , and composites , and finer
blades are for cutting metal, chattering or vibration may indicate you need fine
To Next Page
Loading...
