Galaxy GS-105HS User Manual

1
Operation Manual
(GS-105HS)
Safety Instructions
When using your heat press,
basic precautions should be followed,
including the following:
1. Read all instructions.
2. Use heat press only for its intended use.
3. To reduce the risk of electric shock, do not immerse the heat press in water or
other liquids.
4. Never pull power cord to disconnect from outlet, instead grasp plug and pull to
disconnect.
5. Do not allow power cord to touch hot surfaces, allow heat press to cool completely
before storing.
6. Do not operate heat press with a damaged cord or if the equipment has been
dropped or damaged. To reduce the risk of electric shock, do not disassemble or
attempt to repair the heat press. Take it to a qualified service person for
examination and repair. Incorrect assembly or repair could increase the risk of fire,
electric shock, or injury to persons when the equipment is used.
7. This appliance is not intended to be used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
8. Close supervision is necessary for any heat press being used which can be sure
to keep children away from the equipment. Do not leave equipment unattended
while connected.
9. Burns can occur when touching hot metal parts.
10. To reduce the likelihood of circuit overload, do not operate other high voltage
equipment on the same circuit.
11. If an extension cord is necessary, then a 20-amp rated cord should be used.
Cords rated for less amperage may overheat. To arrange the cord in a correct way
so that it cannot be pulled or tripped over.

Galaxy GS-105HS Specifications

General

Brand	Galaxy
Model	GS-105HS
Category	Power Tool
Language	English

Summary

Safety Instructions

Technical Parameters

Machine View

Operation Instructions

Control Panel Guide

Overview of the heat press control panel and its functions.

Assemble the Control Box

Step-by-step guide for mounting the control box to the heat press machine.

Connecting the System

Instructions for connecting the heat press power cord to a grounded electrical outlet.

Ramspin System Operation

Details on the auto and manual switch functionality of the Ramspin system.

Turning the System On

Procedure for powering on the heat press and its components.

Adjusting the Temperature

Guide to setting and adjusting the desired temperature for heat pressing.

Adjusting the Time

How to set and adjust the timer for the heat pressing cycle.

Counter Setting

Instructions for setting and using the press cycle counter.

Adjusting the Pressure

Methods for adjusting the pressure level on the heat press.

Printing and Pressing

Steps for positioning garments and initiating the heat pressing cycle.

Switching Temperature Units

Procedure to switch temperature display between Fahrenheit and Celsius.

Temperature Calibration

Guide on calibrating the temperature sensor for accurate readings.

Exploded Views

Sliding System Components

Diagram and part list for the heat press sliding system.

Ramlock System Components

Diagram and part list for the Ramlock system.

Optional Platens

List of available optional platens for the heat press.

Electrical Schematic