General Cleaning
(continued)
r _ The door isheavy. For
safe, temporary storage, lay the door
flat with the inside of the door facing
down.
Liftdoorstraightoff 2 doorhinges
To Remove and Replace Oven Door
To Remove Oven Door
1. Completely open the oven door.
2. Removescrewslocated on the insideof the oven door near the hinges
(one on each side).
3. Closethe door to the quarter-open position. Grasp the door firmly on
both sidesand lift up and offthe hinges.
4. To clean oven door, follow the instructionsprovided in the cleaning chart
under General Cleaning.
To Replace Oven Door
1. Be sure the hinge arms are in the quarter-open position, Be careful if
pulling the hinges open by hand. The hinges may snap back against the
oven frame and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots
at the bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should
be inserted into the bottom corners of the door as far as they can go.
4_ If the door is not in line with the oven frame, remove it and repeat the
above steps.
5. Replace screws previously removed.
Figure 1
Figure 2
To Remove and Replace Oven Bottom
To Remove Oven Bottom:
1. Remove the oven racks.
2. Remove the two hold-down screws (Figure 1) at the rear of the oven
bottom panel. If the screws are too tight to remove by hand, use a
screwdriver.
3, To lift out the bottom panel, place fingers in the slots in the bottom. Lift
the rear of the panel up and back until it is clear of the lip at the front of
the panel (Figure 2).
4. Lift the bottom up and out.
To Replace the Oven Bottom:
1. Place the oven bottom in the oven with the back raised about 6" or until
you can insert the front of the oven bottom under the hold-down lip at
the front of the panel.
2. Push the back of the oven bottom down fully into place on the metal
flanges and insert the hold-down screws.
Changing Oven Light
(some models)
To Change the Oven Light (some models)
1. Turn electrical power off at the main source or unplug the range.
2. Replace bulb with a new 40 watt appliance bulb.
3. Turn power back on again at the main source (or plug the range back in).
4. The clock (if equipped) will then need to be reset. To reset, see Setting
the Clock and Minute Timer in this Owner's Guide.
Be sure the range is unplugged and all parts are COOL before
replacing the surface or oven lights. Wear a leather-faced glove for
protection against possible broken glass.
12
To Next Page
Loading...
