Gallagher Fence Control - Page 17

GE - Fence Control
- V1.1
17
SMS commands - System
Querying the geoposion
Query the current posion of the Fence Control, if this is
can be determined. The response contains the latude and
longitude determined by the Fence Control determined
latude and longitude
and the approximate height. The given coordinates may,
depending on signal strength, vary by a few to
a few hundred metres.
To determine geoposioning, the Fence Control
must be placed in the open eld. AtIndoors, the
posion of the Fence Control cannot be determined.
The posion determinaon can take several hours.
Firmware version and rmware update
Querying and updang the current rmware of the Fence control
Parameter descripon
<CMD> ...reset to factory sengs update
Install newer rmware
(oponal)
<PIN> ...alphanumeric PIN of your fence controller
(oponal)
Without parameters
Querying the rmware version of the Fence Control
Firmware reset <PIN> (administrator only)
Reseng the Fence Control to the factory seng
rmware update <PIN> (administrator only)
When new rmware is available, Fence Control downloads and installs it. This usually takes about 15
minutes, but can take considerably longer in poor wireless condions. The Fence Control's web must
be acve for this (see "web" command on page 12) and your mobile phone subscripon requires
sucient available internet data volume (an update requires about 512kb of data).
Coordinates Fence Control meadow
N 46.73914
E 13.08164
Height: 600
Next update in 35min
osm.org/?
mlat=46.73914&mlon=13.08164
1: +12 345 67 89 (Administrator)
2: +98 765 43 21
3: ...
Fencing control pasture: Fenceware
3.0.9-86ef461
Compiled on 21 Dec 02:16:10 CET
2023
Fence management meadow:
Firmware
Update passed!
Fenceware 3.1.0-45ac481
Compiled on 21 Dec 02:16:10 CET 2023
help