Need help?Do you have a question about the Gallien-Krueger 2000RB and is the answer not in the manual?
General| Power Output | 200 Watts |
|---|---|
| Channels | 2 |
| EQ | 4-Band EQ |
| Effects Loop | Yes |
| Type | Bass Amplifier |
| Preamp | Solid State |
| Power Amp | Solid State |
| Voicing Filters | Contour |
| Inputs | 1 x 1/4" Instrument Input |
| Outputs | 1 x XLR Output |
| Dimensions | 48.3 cm x 8.9 cm x 21.6 cm |
Details power output (500W/ch, 1000W bridged), high current capacity, low noise, and dual power supplies.
Covers the three operating modes (Bridge, Biamp, Stereo), fault detection, and fan cooling.
Lists tuner output, voicing filters, EQ, boost stages, effects loop, balanced output, crossover, and Speakon connectors.
Details the input jack, -10dB Pad, CLIP indicator, TUNING MUTE, and VOLUME control.
Explains the use of BOTTOM, CONTOUR, PRESENCE voicing filters and Active EQ controls.
Covers BOOST 1, BOOST 2, LEVEL, AUX LEVEL, and master volume controls.
Describes CLIP, PROTECT, POWER LEDs, and the main POWER SWITCH.
Details the RF2 Footswitch jack, Stereo Aux In, HI-OUT, and LOW-OUT signal outputs.
Explains the crossover switch, frequency control, and series effects loop (RETURN/SEND).
Covers PRE/POST selection, BAL. LEVEL, GND LIFT, Bal. Out, and TUNER OUT.
Details the SPEAKON™™ CONNECTORS for connecting speaker cabinets.
Table detailing 2000RB output power by speaker impedance and operating mode.
Instructions for configuring and connecting speakers for Bridge Mode operation.
Instructions for connecting speakers and using the amplifier in Stereo Mode.
Instructions for connecting speakers and using the amplifier in Biamp Mode.
Guide to connecting the bass, setting initial controls, and powering up the amplifier.
Adjusting bass output and using the -10dB PAD to avoid input clipping.
Optimizing volume for low noise and adjusting voicing filters for desired tone.
Using Active EQ, BOOST controls, and MASTER for final tone and loudness.
Connecting effect pedals directly to the amplifier's input jack.
Utilizing the amplifier's dedicated series effects loop for effects.
Configuring parallel effects loops for blending effects with the main signal.
Instructions for parallel effects in Bridge, Stereo, and Biamp modes.
Detailed technical specifications for preamp, power amp, and active EQ sections.
Specs for voicing filters, impedances, footswitch, and physical dimensions.
Information on cooling, protection features, power supply, and consumption.
Diagnosing issues with unit lights, fault LEDs, and lack of sound output.
Resolving problems with hum, noise, distortion, and low loudness.
Troubleshooting issues with tuning mute, boost functions, or footswitch operation.
To Next Page