INSTRUCTIONS FOR UNDERWATER LIGHT SHOW & FOUNTAIN™
NOTE: This product should be operated in at least 12 inches of water to get the maximum water height.
IMPORTANT: Place in water before turning on fountain.
BATTERY INSTALLATION
Make sure the product is thoroughly dry before replacing batteries.
1. Turn cap on battery casing counter clockwise to open.
2. Remove battery cover and insert four (4) “D” batteries.
3. Line up the notch of the battery cover with the notch on the battery casing and press firmly.
4. Screw cap on battery casing and tighten securely to ensure that water does not seep into
battery casing.
To replace the batteries in the remote control
1. Unscrew battery door on the back of the remote control.
2. Lift battery door off and remove batteries.
3. Insert two (2) “AA” batteries.
3. Re-insert battery door and screw closed. Make sure to tighten securely.
NOTE!
ON/OFF & SELECTING THE LIGHT SHOW
All the shows can be controlled by using the button on the unit or by the remote control.
The Underwater Light Show and Fountain offers multiple light shows for the fountain and for the underwater light
show. Mix & match the fountain and the underwater light shows to create your own water and light fantasy. There
are many combinations to choose from.
FOUNTAIN SHOWS UNDERWATER LIGHT SHOWS
Disco Party Lights Flash Randomly
Fountain can be turned on without the lights All Lights On
Randomly cycles through all shows
ON/OFF/MODE BUTTON ON UNIT
The left side of the button controls the fountain light show;
the right side controls the underwater light show.
the product shuts off (approximately 3 seconds).
continued
To Next Page
Need help?
General