Kit Contents:
• 64HD PCB
• HDMI daughter PCB
• RCP ex cable
• 15 pin FFC
• No cut AV shroud
• HDMI PCB mounting bracket
• 2x 5mm M2 screws
Tools Required:
• Gambit screw driver
• Phillips size 0 and 2
• Soldering iron (ne tip recommended for drag soldering)
• Solder (Leaded recommended, leadless can lead to poor solder joints and other
issues with the installation. Use unleaded at your own risk)
• Flux (liquid or normal will work ne)
• Wire gauge 30 to 32 (too small of gauge will cause issues, 34 and smaller)
Page 3
Gamebox
LLC
can, in no way, be held liable for any damage to the user’s property, or the user’s health from
following these instructions. While these instructions aim to give the user a comprehensive and safe guide to
completing this modifcation, there are many potential variables that could result in the unit that the user is
attempting to modify requiring more restorative measures. ere is also a serious risk of, injuries, and death
when working with electronics. At the time of this guide’s writing these consoles are rapidly aging, and even
working units should be recapped as soon as possible. Chemicals associated with some of these processes are
quite toxic and should be handled with care and adult supervision. Results may vary. “64HD”, “Gamebox”,
“Gamebox Systems”, “gamebox.systems”, its associated internet domains, and the associated logos in this
document are trademarks(™) of Gamebox
LLC
, A Limited Liability Company. is document, text and, images
contained there-in are property of Gamebox
LLC
©2023 Gamebox
LLC
, all rights reserved.
Legal Disclaimer
To Next Page
Loading...