24
TROUBLESHOOTING TIPS
PROBLEM SOLUTION
String slips in clamps - Adjust gap between clamp jaws
- Clean clamp jaws
String slips in gripper - Adjust gripper jaw stop screw
- Clean gripper jaws
String clamp base slips on turntable - Clean bottom of clamp & top of turntable with
alcohol
- Adjust clamp base locking nut
String tension too tight or too loose - Check tension using a tension calibrator,
adjust machine calibration if necessary
Electrical system does not function - Check power source
- Check power cord connections
CARE & CLEANING
With time and use, the clamping surfaces of your machine may become oily or dirty and result
in string or clamp slippage while stringing. Periodic cleaning of the String Clamps, String Clamp
Base and String Gripper is recommended. The supplied Cleaning Stone or a knife sharpening
stone works well for cleaning the diamond coated string clamping surfaces. Cleaning with a
solvent such as isopropyl alcohol and a mild abrasive tool such as a toothbrush also works
well to remove oily or greasy build up.
To Next Page
Loading...
