11
STRINGING THE FRAME
Weaving the Cross Strings
Weave the cross strings over and under the
main strings being careful to alternate the
weave direction of each consecutive cross
string so as to be opposite of the previously
installed cross string.
Completing the String Job
Once the nal cross string is tensioned and
clamped, tie off at the appropriate hole speci-
ed by the racquet manufacturer. Remove the
frame from the mounting system by loosening
the shoulder supports and frame supports.
Clamping the First Main String
Secure the tensioned main string using the
remaining xed clamp. Repeat the procedure
for all of the remaining main strings and
tie off following the racquet manufacturers
recommendations.
Follow the manufacturer’s recommended
stringing pattern for one or two piece stringing.
This will determine the starting point for the
cross strings. If applicable, tie the rst cross
string using an appropriate starting knot.
To Next Page
Loading...
