Gamma X-Stringer XLT - STRINGING COMPLETION; Securing Main Strings; Weaving Cross Strings; Finalizing the String Job

To Next Page

To Previous Page

STRINGING THE FRAME

Weaving the Cross Strings

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Completing the String Job

Once the ﬁ nal cross string is tensioned and

clamped, tie oﬀ at the appropriate hole speci-

ﬁ ed by the racquet manufacturer. Remove the

frame from the mounting system by loosening

the shoulder supports and frame supports.

Clamping the First Main String

Secure the tensioned main string using the

remaining ﬁ xed clamp. Repeat the procedure

for all of the remaining main strings and

tie oﬀ following the racquet manufacturers

recommendations.

Follow the manufacturer’s recommended

stringing pattern for one or two piece string-

ing. This will determine the starting point for

the cross strings. If applicable, tie the ﬁ rst

cross string using an appropriate starting

knot.