To Next PageTo Next Page
Need help?Do you have a question about the Gandy 10T Series and is the answer not in the manual?
Details total grease fittings, frequency, and specific lubrication points like wheel hubs, bearings, and knee lever.
Explains operating the clutch lever for 'Out of Gear' and 'In Gear' positions.
Procedures for removing, cleaning, and reinstalling rotor bars and stub drives.
Steps for cleaning buildup, removing rear hangers, and reassembling slides.
Safety decals, spread-plate angles, and Cam-Gauge settings.
Using calibration pans and known area methods for rate verification.
Lists parts included in powder angle packages and installation instructions.
Lists standard equipment and general spreader capacities and dimensions.
Details specifications for Pull-Type, End Wheel Driven, and Implement Mounted models.
General