Gannet Pro - Payload Release System; Operation Instructions; Drop Loop Importance

Payload Release System
1. Tension Adjustment Wheel
2. Tension Adjustment Indicator
3. Easy Release Arm (for baits over 800g)
4. Release balls
Operation Instructions
1. Put the release switch into the on position.
2. Load bait, sinker and 2 additional 7 ounce sinkers.
3. Adjust tension wheel until the load drops.
4. Reload the bait with the sinker, excluding the 2 sinkers for setup.
5. When in position, ip the release switch into the unlocked position to release your payload.
Drop Loop
A drop-loop is an essential part that has saved countless drones
from failure
By utilising a drop-loop, the main line is kept far away from
drones props.
We recommend using a long running drop loop of at least 1-3m
minimum the bait hangs a further 3-20m below that.
By having the bait (weight) far away from the drone, the swing-
ing of the bait (pendulum eect) is allot slower and less violent,
by doing this, It greatly increases drones stability.
e pendulum eect this is magnied with a short drop line and
has also caused drones to crash. Short drop loops are known to
swing up and cause crashes.