Quick Start Guide
Drone:
Installing the Propellers
• Always ensure that the correct propellers is installed on the correct motors, they are match marked with
either no markings as for Front Right and Back Le or with circles as for the Front Le and Back Right
motors.
• Make sure the propellers are slightly nipped tight so that they can not unscrew themselves.
Installing the Battery
• Slide it in with the terminal downwards and securely plug in the connector, it can only go in one way
with the black negative wire to the le.
• Close the battery door and loosely tighten the retaining screws evenly at the same time to ensure a good
seal, do not over tighten them, as they can strip.
• Always ensure that the screws and brass nut thready are lubricated with vasaline to prevent corrosion and
seizing of the threads.
Setting the release
• e release must be set to release when approximately 400g of pressure is added to the load (bait plus
sinkers) that will be own. Over setting the release tension can result in a failed release. Ensure release is
set when the release is in a closed / locked position.
DO NOT use the easy loader arm for baits under 800g. For baits under 800g connect the drop-loop directly onto
the ball-bearings (ensure that the release is correctly set to the release tension according to the thickness of the
drop-loop line).
Ensure that your lines are out of the way of the propellers for takeo, if a line gets into the props the drone will
crash. (See Drop-loop section)
To Next Page
Loading...