Gannet Pro - On Startup; Startup Procedures and Indicators

On startup:
• ALWAYS switch on the remote rst, failure to do so can result in a y away, on power up of the
drone a rapidly ashing orange indicator light on the drone will indicate that the remote is not on. In this
instance power the drone o, power the remote on and aer waiting at least 3 seconds power the drone
on again.
• Always ensure the two right hand toggle switches are ipped to the top for GPS and Normal ight modes,
• NEVER move the drone during initial warm-up, if you did pleased power down for at least 3 seconds and
restart, the second time round it will already be warm and will boot up much faster,
• NEVER power down and restart in rapid succession as this will trigger the watter-ip function and one
motor will not start up. e drone takes a few seconds to power down fully.
• On initial power up the indicator LED will ash orange at a rate of about one ash per second,
this indicates warming up.
• Aer warm-up, the indicator LED may ash orange and red in succession this means the drone requires
a compass calibration, follow the calibration steps.
• If no calibration is needed the LED will change to ash either Red Red Green or Red Red Orange. is
indicates what ight mode you are in whilst the drone is looking for satellites Green = GPS and
Orange = Atti,
• If the n LED changes to rapid orange ashes it is in RTH mode,
• Once good GPS lock is obtained in GPS mode the ashes will change to a steady Green ash, as soon as
the home point is saved 5 rapid Green ashes will indicate this and it is safe to y.