Need help?Do you have a question about the Gantner Q.bloxx D107 and is the answer not in the manual?
General| Brand | Gantner |
|---|---|
| Model | Q.bloxx D107 |
| Category | Measuring Instruments |
| Language | English |
Defines intended use, checking for transit damage, and requirements for personnel operating the modules.
Covers special risks, siting, modifications, servicing, disposal, and general hazards from non-compliance.
Explains DANGER, WARNING, CAUTION, NOTICE symbols and their implications for preventing hazards.
Details CE marking, CAT ratings, and symbols used within the manual for clarity.
Describes the Q.bloxx documentation range, including manuals and online resources.
Explains the Q.bloxx system, operating via Q.gate, Q.pac, or without a Test Controller.
Details on connecting the base, DIP switches, hot swap, address settings, termination, mounting, and extension sockets.
Covers connecting the power supply, fitting, and removal of modules from bases for safe operation.
Explains connecting modules via Q.gate/Q.pac, Ethernet, RS-232, and direct PC/PLC connections.
Covers synchronizing systems, radio/GPS receivers, module flashing frequencies, and LED status indicators.
Details connection options and specifications for specific Q.bloxx modules (A101-A128, D101, D104-D107).
Guides on installing test.commander, using the software, and establishing connections via Ethernet or serial interface.
Details setting sensor parameters, scaling, zero balancing, and configuring digital inputs/outputs.
Covers Q.gate/Q.pac settings, module interfaces, synchronization, online tools, and firmware updates.
Explains serial interfaces, bus termination, connection technology, network topologies, and Ethernet PC configuration.
Guides on connecting sensors with sensing leads, scaling, current measurement, and thermocouple measurements.
Provides contact details for Gantner Instruments GmbH in Austria and Germany, and information on technical resources.
To Next Page