4. PROGRAMMING v (Fig. G – I)
Fig. G:
1 Set time (hours) | 2 Set time (mins) |
3 Select schedule | 4 Confirm schedule
Please note: If starting in the past and at a fre-
quency of 4, 6, 8, 12 hours, the start time will
be automatically adjusted after input.
Watering tip: For pot plants that required small
amounts of water at regular intervals, short water-
ing cycles are ideal in combination with a drip
irrigation system.
The saved watering schedule can be activated or
deactivated by pressing ON / OFF.
Fig. I: 1 Active watering | 2 Change watering duration |
3 Stop active watering at any time
By pressing the button, manual watering can
be started or stopped at a desired time (see fig. I ).
Soil Moisture Sensor, Art. 1188,
(optionally available) v (Fig. D and H):
1 Menu: Soil Moisture Sensor
After a soil moisture sensor is connected,
the word “Sensor” will be displayed.
This can take up to 1 minute. The soil moisture
level at which a watering will not be carried out
as per the schedule can be set using the switch-
ingpoint controller on the soil moisture sensor
(see GARDENA Soil Moisture Sensor Operator’s
manual). This does not affect active manual
watering.
3. FUNCTION v (Fig. F)
The settings can be adjusted when the control
panel is removed. You can change the settings
or move to the next setting by turning the outer
wheel. Pressing the
button confirms the
respective input. Pressing the button for a mini-
mumof 3 seconds locks or unlocks the display.
max. 1 year
min. 4 weeks
max. 4 weeks
too weak for opening again
*
Battery
Condition *
Soil Moisture
0 drops = Sensor
detects “dry”
3 drops = Sensor
detects “wet”, no
time-controlled
watering
Time
Connected
sensor
Start Time
(0 – 23) hrs (0-59) min.
Run Time
(0 – 29) sec.
(0 – 99) min.
Frequency
4, 6, 8, 12, 24,
48, 72 hrs
ON
min
hrs
sec
Sensor
Active
Watering
Timeplan
active /
deactive
ON OFF
If you will be away for long periods of
time, please replace the battery when
the battery symbol blinks – otherwise
the watering system may fail.
6
EN
To Next Page
Loading...
