first removing all fuel from the fuel tank, as doing so might cause fuel to leak
from the tank.
■ OPERATING SAFETY PRECAUTIONS
1. Grip the handles of the brush cutter firmly with both hands. If you require a
short break, place the throttle into the idling position.
2. Always be sure to maintain a steady, even posture while working.
3. Maintain the speed of the engine at the level required to perform cutting work,
and never raise the speed of the engine above the level necessary.
4. If the grass gets caught in the blade during operation, or if you need to check
the unit or refuel the tank. Always be sure to turn off the engine.
5. If the blade touches a hard object like a stone, immediately
stop the engine and check for damage to the blade. If so,
replace the blade with a new one.
6. If someone calls out wile working, Always be sure to turn off
the engine before turning around and entering into a
conversation.
7. Never touch the spark plug or plug cord while the engine is
operation. Doing so may result in being subjected to an
electrical shock.
8. Never touch the muffler. Spark plug，or other metallic parts
of the engine while the Engine is in operation or immediately
after shutting down the engine. Doing
so may result in serious burns.
9. When you finish cutting in one location and wish to continue work in another
area turn off the engine and turn the unit away from yourself so that the blade
faces away from your body..
■ MAINTENANCE SAFETY PRECAUTION
1. Perform the maintenance and checking operations described in this manual at
regular intervals. If any parts must be replaced or any maintenance or repair
work not described in this manual must be performed, please contact a
representative from the nearest authorized servicing dealer for assistance.
2. Under no circumstances should you ever take apart the brush cutter or alter it
in any way. Doing so might result in the brush cutter becoming damaged
during operation or the brush cutter becoming unable to operate properly.
3. Always be sure to turn off the engine before performing any maintenance or
checking procedures.
4. When sharpening, removing, or reattaching the blade always uses proper
To Next Page
Loading...