Replacing the blade
For safety reasons, we recommend having the blade replaced by an
authorized professional.
Important!
Wear work gloves!
Only replace the blade with a genuine Einhell replacement blade, as
this will ensure top performance and safety under all conditions.
Carry out the following steps to change the blade:
• Undo the fastening screw (Fig. 7).
• Remove the blade and replace with a new one.
• When fitting the blade, make sure it is installed in the right
direction. The blade’s air vanes must jut into the motor
compartment.
• Then retighten the fastening screw. The tightening torque
should be approx. 25 Nm.
Carbon brushes
• In case of excessive sparking, have the carbon brushes
checked only by a qualified electrician. Important! The
carbon brushes should not be replaced by anyone but a
qualified electrician.
Maintenance
• There are no parts inside the equipment which require
additional maintenance.
Helpline No. UK/Northern Ireland 0151 6491500
Rep. Ireland 1890 946244
Model Number: 41688
19
Please quote the following data when ordering replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
For our latest prices and information please go to www.isc-gmbh.info
Ordering replacement parts
To Next Page
Loading...
