stopper 4 . If certain length left outside the hose box main body 1 , pull out
the outlet hose 7 by 1-2m and roll up again. Do not push the hose back into the
hose box main body 1 .
7. Turn off the tap water and rotate the hose box main body 1 against the wall.
Cleaning and maintenance
Any work that is not described in these Instructions must be carried out by a
servicing agency authorized by us.
- Always keep the hose box main body 1 clean. Do not use cleaning agents and
solvents.
-
Always turn off the tap water when the wallmounted hose box is not in use
-
Use the water spray to clean the hose box main body
1
. Do not immerse the
wall-mounted hose box in water.
-
Remove the hose box main body 1 indoors in a frost period (See “Storage”).
-
Check the inlet hose
12
and outlet hose
7
carefully. Do not use the hose box if
any cut on them.
-
Check the seal O-ring on nozzle holder
8
and faucet coupling
14
.
-
Regularly check and clean the inside through the flap
3
.
-
Contact our service center if any problem.
Storage
1. Carefully clean the hose box main body
1
and its accessories.
2. Turn off the tap water and remove the inlet hose male coupling
13
from the
faucet coupling
14
.
3. Use one hand to grip the main body carrying handle
2
and another hand to
pull out the hose box fixing bar
6
.
4. Remove the hose box main body
1
from wall-mounted bracket
5
and insert
the hose box fixing bar
6
back.
5. Carry the hose box main body
1
indoors for storage.
Troubleshooting
Problem
Possible cause Remedy
Lock / unlock defect different turn Repeat the action (See
“locking / unlocking outlet
hose”).
Operation
17
To Next Page