- Make sure that no water pipes are damaged during
installation of the product. Observe the operating instructions
for your safety.
- Ensure that all parts are undamaged and have been
assembled appropriately. Risk of injury exists if assembled
incorrectly. Damaged parts can effect safety and function.
-
Have the installation done by experienced persons only.
-
Do not open the housing. The springs are preset; they may
spring back.
- Never remove any screws from parts of the housing.
-
Never let the hose spring back by itself. Guide it carefully back
into the housing.
- Never let go of the hose if the automatic stop function is not
engaged.
- Never allow the hose to retract freely. This could result in
damage to the product.
- Never block the hose end with your fingers or other objects
during use.
- To avoid frost damage, remove the hose reel from the wall
and store it dry during winter.
- Ensure that the ground near the hose reel is kept as dry as
possible.
- Turn the tap into the off position when the hose reel is not in
use.
- The hose is not suitable for delivering drinking water.
- Do not direct the water jet towards electrical equipment!
- Do not direct the water jet towards persons or animals!
Safety
8
To Next Page
Loading...