Need help?Do you have a question about the Gardner Denver L290 RS 190A V2 and is the answer not in the manual?
General| Model | L290 RS 190A V2 |
|---|---|
| Category | Air Compressor |
| Type | Rotary Screw |
| Power | 190 kW |
| Drive Type | Direct Drive |
| Cooling Method | Air Cooled |
| Noise Level | 75 dB(A) |
Organizational measures and general safety advice for compressor operation.
Details hazards related to electricity and noise exposure.
Lists and describes protective equipment like emergency stop and safety valves.
Covers electrical hazards, spring tension, contamination, transport, and installation safety.
Covers safe operation, special work, maintenance precautions, and cleanliness.
Specifies required clearances, foundation, and site conditions for installation.
Instructions for making the electrical connection to the compressor.
Steps for initial compressor setup and checks before operation.
Procedures to check the correct rotation of motors and fans.
Covers normal operation states, observations, shutdown, and emergency stop usage.
Lists potential fault causes and remedies for unit not starting.
Remedies for faults during run-up and failure to reach network pressure.
Potential causes and remedies for unit switching off.
Addresses high idle pressure, oil in filter, and safety valve faults.
Target group for maintenance, safety measures, and pressure relief.
Safety for electrical parts, water-cooled units, and service contact.
Checks for protective covers, safety valves, and emergency stop function.
Covers safety valve checks, routine tasks, electrical checks, leaks, and materials.
Details maintenance tasks and schedules based on operating hours and time.
Technical specifications for L160-L200 models at 60Hz, air and water-cooled.
Technical specifications for L250-L290 models at 60Hz, air and water-cooled.
To Next Page