Gardol GEMI 1200 - User Manual

Questions and Answers

D
Denise BurnsAug 3, 2025
How to fix Gardol GEMI 1200 if the motor cannot be started?
- M
  Michele MitchellAug 3, 2025
  If the Gardol Tiller motor won't start, first check the mains supply to ensure there is power. Inspect the cable for damage; if damaged, pull out and reinsert the plug. If that doesn't work, replace the cable or have it repaired by a qualified electrician. A damaged safety switch/plug combination will require repair by a specialist workshop. Also, the overheating protection might be activated. In that case, either reduce the working depth, remove any blockage from the tines, or if the soil is too hard, adapt the working depth and work the soil by repeatedly moving forward and backward over the same place. Let the motor cool down for about 15 minutes before resuming work.
M
mckinneymichaelAug 10, 2025
What to do if my Gardol Tiller is making unusual sounds?
- D
  Debbie TurnerAug 10, 2025
  If your Gardol Tiller is making unusual sounds, switch it off and wait for the motor to stop completely. Then, check if the tines are blocked and eliminate any blockage. If lubricating agent is leaking, have the tool repaired by a specialist workshop. Also, verify that all screws, nuts, and fastening elements are tightened. If the sounds persist after tightening, contact a specialist workshop.
B
Brandi FosterAug 17, 2025
Why is my Gardol GEMI 1200 vibrating so strongly?
- D
  David GentryAug 17, 2025
  If your Gardol Tiller is vibrating unusually strongly, the tines might be damaged or worn out. Consider replacing the tines or having them checked by a specialist workshop. Also, the working depth may be too deep; adjust it to a more suitable level.
A
Anthony SimsAug 25, 2025
How to improve bad tilling result with Gardol GEMI 1200?
- A
  Anthony WilliamsAug 26, 2025
  If you're getting a bad tilling result with your Gardol Tiller, it might be because the working depth is too low; adjust it to a more suitable depth. Alternatively, the tines could be worn out or blunt; replace them or have them checked by a specialist workshop.