Assembly and Installation Instructions for
Model 75006 Seat Slide Assembly
with Swivel
Form 12.112
ASSEMBLY INFORMATION
1. Check parts against parts list.
2. Read instructions completely before starting assembly.
3. NOTE: This product uses Iocknuts for a secure assembly.
Locknuts thread on harder than conventional nuts and require
a screwdriver and wrench for attachment.
TOOLS REQUIRED
1. Screwdriver
2. Drill
3. Wrench adjustable to 7/16”
ASSEMBLY INSTRUCTIONS
1. Take swivel (A), rotate its top and bottom halves so slotted holes
on bottom plate are exposed (fig. 1) and mark their position at
desired mounting location on boat.
2. Align slotted holes of both swivel (A) and slideplate (B). Refer to
fig. 1 and insert screw (C) through slideplate (B), polywasher
(D), washer (E), swivel (A) and secure with Iocknut (F). Repeat
step 2 for the three other slotted holes.
3. Determine in which direction slide travel Is desired (see fig. 2)
and then position aluminum tracks (G & H) on seat bottom as
illustrated in fig. 3. NOTE: Decide which side of seat locking rod
(N) is desired and then place aluminum track (G) on that side of
seat bottom.
4. Attach both tracks (G & H) to seat bottom by aligning the four
slotted holes #1 in tracks and the four machine-threaded T-nut
insert holes in seat bottom. Insert four 1/4-20 x 1” machine
screws (I) (provided with EEz-In
®
seats) and use lockwashers (J).
Screw them loosely into holes.
5. Grease the grooves of aluminum tracks (G & H) and the open
sides of slideplate (B).
please turn to other side
FIG. 1
FIG. 2
Write for
a Complete
Catalog
Phone: 651-459-9795
PO Box 8, 644 2nd Street E-mail: mail@garelick.com
St. Paul Park, Minnesota 55071 On the Web: www.garelick.com
4/04
Parts List for Model 75006
Ref. Factory No.
Letter Part No. Req. Description
A 49.045 1 Swivel
B 59.308 1 Anodized aluminum slideplate
C 03.069 4 1/4-20 x 3/4" hexhead capsrew
D 03.161 4 3/4" x 3/16" poly washer
E 03.125 4 1/4" washer
F 03.017 4 1/4-20 locknut
G 59.306 1 Anodized aluminum track w/hole
H 59.307 1 Anodized aluminum track w/nut
I 4 1/4-20 x 1" machine screw
(supplied with EEz-In
®
seal)
J 03.119 4 1/4" s.s. lockwasher
K 03.116 4 #14 x 1" s.s. screw
L 03.128 1 s.s. 3/8" hole washer
M 03.133 1 1" poly washer
N 59.064 1 s.s. locking rod
s.s. means stainless steel
B
D
E
F
A
C
SEAT FRONT
SEAT FRONT
SIDE TO SIDE
“ATHWART”
FORE & AFT
To Next Page
Need help?
General