P1GXXAS
Portable Tap
Installation Guide
RJ45 Ethernet RJ45 Ethernet
Link Failure Propagation
Link Activity
Supports Breakout, Aggregation and SPAN Modes
Copper media connectivity
Plug-n-Play design with zero configuration
Link Speed Synchronization
Jumbo Frames
Passes physical layer errors on network ports
Supports Link Failure Propagation (LFP)
Monitor Port Speed selectable (100Mbps or 1Gbps)
This portable network TAP series is ideal for 10/100/1000MB copper network
monitoring. The innovative design allows these TAPs to be easily installed into any
copper 10/100/1000MB network segment.
Once installed in your network the P1GXXAS network TAPs will enable you to
monitor your network segments quickly and effectively using a network analyzer,
security devices, or any monitoring appliance or tool. These 100/1000MB TAPs will
allow you to capture full-duplex traffic without dropping any packets or, in the
SPAN Mode the input traffic to be replicated to up to 3 monitor ports.
Supports FailSafe in case of power failure.
Captures Full Duplex Traffic up to 2 Gigabits without
dropping any packets
Small portable form factor: 3.9"x1.15"x6.53" (W x
H x D)
Rack Shelf or Plate supports up to four (4) TAPs in a
1U space
P1GXXAS TAP Key Features
Rear View
Power
Connector
Page 1 Ver 4.8
To Next Page
Need help?
General
