Garmin Fusion MS-RA60

To Next Page

Fusion

MS-RA60 Installation Instructions

Important Safety Information

WARNING

Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor

product performance.

See the Important Safety and Product Information guide in the product box for product warnings and other

important information.

This device must be installed according to these instructions.

Disconnect the vessel's power supply before beginning to install this product.

Before applying power to this product, make sure it has been correctly grounded, following the instructions in

the guide.

CAUTION

To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,

cutting, or sanding.

NOTICE

When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.

You must read all installation instructions before beginning the installation. If you experience difficulty during

the installation, contact Fusion Product Support.

What's In the Box

• Mounting gasket

• Four 6-gauge, self-tapping screws

• Two screw covers

• Power and speaker wiring harness

• Auxiliary-in, line-out, and subwoofer-out wiring harness

Tools Needed

• Phillips screwdriver

• Electric drill

• Drill bit (size varies based on surface material and screws used)

• Rotary cutting tool or jigsaw

• Silicone-based marine sealant (optional)

TA-2021/0772

GUID-3453BF25-825C-403E-917D-EF24C7294A81 v2December 2021

Main Page

Need help?

Do you have a question about the Garmin Fusion MS-RA60 and is the answer not in the manual?

Summary

Wiring Harness and Connector Identification

Stereo Dimension Drawings

Front Dimensions

Provides front view dimensions of the stereo unit for installation planning.

Side Dimensions

Provides side view dimensions of the stereo unit for installation planning.

Registering Your Fusion Device

Summary

Wiring Harness and Connector Identification

Stereo Dimension Drawings

Front Dimensions

Provides front view dimensions of the stereo unit for installation planning.

Side Dimensions

Provides side view dimensions of the stereo unit for installation planning.

Registering Your Fusion Device

The Fusion MS-RA60 is a marine stereo designed for installation on vessels, offering audio playback and control features. It requires careful installation to ensure proper function and water resistance.

Function Description:

The Fusion MS-RA60 serves as a central audio hub for marine environments. It connects to various audio input sources, such as CD or MP3 players, and outputs sound to speakers and optional external amplifiers/subwoofers. The stereo features two powered speaker zones, allowing for independent volume control in different areas of the vessel. It also includes an AM/FM tuner and supports Bluetooth® wireless connectivity for streaming audio from compatible devices. The device can be controlled remotely using the Fusion-Link™ app on Apple® or Android™ devices.

Important Technical Specifications:

General:
- Weight: 316g (11.2 oz)
- Water Resistance: IEC 60529 IPX7 (front), IEC 60529 IPX5 (rear). This means the front can withstand immersion in water up to 1m for up to 30 minutes, and the rear can withstand light jets of water (up to 30 kPa at 3 meters) for up to 3 minutes.
- Operating Temperature Range: 0 to 50°C (32 to 122°F)
- Storage Temperature Range: -20 to 70°C (-4 to 158°F)
- Input Voltage: 10.8 to 16 Vdc
- Current (max.): 15 A
- Current (muted): Less than 190 mA
- ANT® Wireless Range: Up to 3 m (10 ft.)
- Compass-Safe Distance: 15 cm (5.9 in.)
- Fuse: 15 A mini-blade type
- Bluetooth® Wireless Range: Up to 10 m (30 ft.)
- Wireless Frequencies/Protocols: Bluetooth 2.4 GHz at 12 dBm maximum, ANT 2.4 GHz @ 7 dBm maximum.
On-board, Class D Amplifier:
- Output Power per Channel: 4 x 22 W RMS at 14.4 Vdc input, 4 Ohm, 10% THD (Total Harmonic Distortion). The stereo may limit output power to prevent overheating and maintain audio dynamics.
- Total Output Music Power: 4 x 45 W max. 4 Ohm. 180 W max.
- Line Output Level (max.): 5.5 V (peak to peak)
- Aux Input Level (typical): 1 V RMS
Tuner:
- FM Radio Frequency Range:
  - Europe and Australasia: 87.5 to 108 MHz
  - USA: 87.5 to 107.9 MHz
  - Japan: 76 to 95 MHz
- FM Frequency Step: 50 kHz (Europe/Australasia/Japan), 200 kHz (USA)
- AM Radio Frequency Range:
  - Europe and Australasia: 522 to 1620 kHz
  - USA: 530 to 1710 kHz
  - Japan: 522 to 1620 kHz
- AM Frequency Step: 9 kHz (Europe/Australasia/Japan), 10 kHz (USA)
Dimensions:
- Front: 157 mm (6 3/16 in.) wide, 68 mm (2 11/16 in.) high
- Side: 22 mm (7/8 in.) depth from mounting surface, 81.2 mm (3 3/16 in.) total depth, 50 mm (2 in.) mounting depth
- Top: 130 mm (5 1/8 in.) depth, 22 mm (7/8 in.) height from mounting surface, 10 mm (3/8 in.) height from mounting surface at rear

Usage Features:

Speaker Zones: The stereo supports two speaker zones, allowing users to group speakers in different areas and control their audio levels independently. Zones 1 and 2 are powered by the on-board amplifier.
External Amplifier/Subwoofer Support: For enhanced audio, the stereo provides RCA line outputs for Zone 1 and a subwoofer output, requiring connection to an external amplifier. The subwoofer level for Zone 1 can be adjusted.
Audio Customization: Users can set the balance, volume limit, tone, and name for each zone.
Dimming: Connects to the boat's illumination wire to dim the stereo screen when the lights are on.
Auxiliary Input: Features a red and white RCA stereo line input for connecting external audio sources like CD or MP3 players.
Remote Control: Compatible with the Fusion-Link™ remote control app for Apple® or Android™ devices, enabling convenient control.
Antenna Connection: Connects to a typical AM/FM antenna using a Motorola type connector. Specific antenna types (ground-dependent or ground-independent) are recommended based on the vessel's hull material (metal or non-metal).

Maintenance Features:

Software Updates: Users are advised to update the software in all Fusion devices at the time of installation to ensure compatibility. Updates can be performed using the Fusion-Link™ app.
Installation Guidance: The manual provides detailed instructions for mounting and wiring, emphasizing the importance of proper grounding, water-tight connections (using a mounting gasket or silicone-based marine sealant), and avoiding damage during installation.
Safety Warnings: Includes warnings about potential personal injury, vessel damage, or poor product performance if installation guidelines are not followed. Advises wearing safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
Product Registration: Encourages users to register their device online at www.fusionentertainment.com and keep the original sales receipt for better support.