Gastroback Design Juicer Advanced Pro - Movable and Sharp-Edged Parts - Risk of Injuries; Technical Specifications

•  immersethemotorhousingorpowercordinwateroranyotherliquid.
pourordripanyliquidsonthemotorhousingorpowercord.Whenliquidsarespilledonthe
motor housing, immediately unplug the appliance and dry the motor housing to avoid risk of
electric shock or fire. attempttooperatetheappliance,whenliquidsareonorinthe
motor housing.

• Thefeedchuteisdesignedexceedinglylarge.Neverputfingers,woodenspoonsorother
foreign substance (such as hair, clothing, brushes, cloths) into the feed chute when the appli-
ance is plugged into the power point.
• Alwaysturntheapplianceoff,waitforthemotortostopmovingandthenpulltheplug
before taking off the lid of the juicer.
• Onlyusetheprovidedfoodpushertopushfoodthroughthefeedchute.
• Neverholdyourfaceorotherbodypartsoverthefeedchutewhenthemotorisrunning
because little pieces of food could be thrown out of the feed chute.
• Thebladesonthebaseofthestainlesssteelmicromeshfilterandinsidethefeedchuteare
very sharp. Pay attention when handling the units. Only touch the stainless steel micro mesh
filter on the edge and handle with care when cleaning with the nylon bristle brush. Only store
the appliance completely assembled. This way the blades will be out of reach.
• Neverputforeignsubstanceorhardobjectsintothefeedchute.Removeallinedibleparts
(such as stem, hard peeling and seeds) of the food before putting them into the feed chute.
• Themotorpursuesrunningforalittlewhileafterturningtheapplianceoff.Waituntilthe
motor stops running completely before you open or move the appliance.

Model:
Art. No.: 40133 Design Juicer Advanced Pro
Power supply:
230-240 V AC, 50/60 Hz
Maximum power consumption:
1.380 - 1.500 W
Length of power cord:
approx. 100 cm
Weight:
approx. 7 kg
Dimensions:
approx. 350 x 220 x 430 mm (W x D x H)
Revolutions:
6,500 bis 13,000 per minute
Certification:
These specifications may change without notice.
38