To Next Page

To Previous Page

IV. SWITCHING AMONG DIFFERENT MODES

Pressing MODE switches the Cost/Price area and kWh/Time area among different modes in a circulation pattern.

The following Illustrations show the process. Pay attention to the symbols and units on the two areas.

V. SETTING T1 , T2 AND THE PRICES

Setting the start time and terminal time of Tl

1. Press MODE until the start time or terminal time of Tl is displayed on the screen.

2. Press PRG to enter setting mode.

3. Press PRG to select the desired item you want to adjust. The selected item will blink.

4. Press MODE to adjust the selected item.

5. When all adjustments have been completed, select the last item (the rightest item) by pressing PRG.

6. Press PRG once more to finish the setting.

Setting price T1/kWh and price T2/kWh

1. Press MODE until the total energy cost of T1 (for setting price T1 per kWh only) or the total

energy cost of T2 (for setting price T2 per kWh only) is displayed on the screen.

2. Perform steps 2 through 6 of the Setting the start time and tenninal time of Tl section.

Note:

Price T1 /kWh is the energy price of T1, price T2/kWh is the energy price ofT2.

Questions and Answers:

Need help?

Do you have a question about the GB PM3100 and is the answer not in the manual?

GB PM3100 Specifications

General