To Next Page

To Previous Page

6 register this product online at www.accoeurope.com

getting ready to laminate

NOTE: Your new laminator may emit

a slight odour during the initial

operation Its is normal and will

diminish after a few hours of

operation

Easy Set Up

1 Remove the plastic exit tray from the box and place into the two holes on the back of the

laminator and extend to use Ensure that there is sucient space behind the laminator for the

item to be removed

2 Take the electrical plug and place in an appropriate power source which is near the table you

intend to use

3 The laminator will respond with a single beep and a sequence of brief ashes across the control

panel

Touch Control

4 To use the laminator gently tap the power on button

NOTE: Following power on it will

automatically set to the mic

5 An orange   will ash indicating that the laminator is warming up to the setting which is

indicated by a white light on the control panel

6 If setting indicated by white light on the control panel is not approporaite for your pouch

thickness select the appropriate pouch setting by tapping the micron setting which is indicated

on pouch packaging Your new selection will be indicated by a white light on control panel

Other manuals for GBC FUSION 3000L

Questions and Answers:

Need help?

Do you have a question about the GBC FUSION 3000L and is the answer not in the manual?

General