GBC FUSION 5100L - preparing the laminator; Easy Set Up Procedure; Interactive Menu Selection Guide

GB
6 register this product online at www.accoeurope.com
getting ready to laminate
Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sucient space behind the laminator for the
item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
3 The laminator will briey ash the GBC logo on the control panel and will make an audible beep.
4 To use the laminator gently tap the ‘power on’ button.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
Manual Select ( ) – scroll through and select the required micron setting, i.e. 75mic.
NOTE: If 40mic setting is selected
ALWAYS use a carrier
mic40
mic75
mic125
mic175
mic250
Interactive Menu Selection
5 A GBC logo will show in the screen followed by the main menu:
MANUAL SELECT AUTO POUCH SELECT
SETTINGS HELP
NOTE: Use arrows to scroll up/down and left/right, use ENTER button
to select.
Use at anytime to go back – one screen at a - time to the main
menu.