5
Guarantee
Operation of this machine is guaranteed for one year from date
of purchase, subject to normal use. Within the guarantee period,
ACCO Brands will at its own discretion either repair or replace the
defective machine free of charge. Defects due to misuse or use
for inappropriate purposes are not covered under the guarantee.
Proof of date of purchase will be required. Repairs or alterations
made by persons not authorised by ACCO Brands will invalidate
the guarantee. It is our aim to ensure that our products perform to
rights which consumers have under applicable national legislation
governing the sale of goods.
Maintenance and care
8
WARNING: UNPLUG THIS PRODUCT BEFORE CLEANING THE
EXTERIOR. WIPE EXTERIOR ONLY WITH A DAMP CLOTH AND
DO NOT USE DETERGENTS OR SOLVENTS.
Regularly feed a cleaning card or sheet of paper through the
laminator to clean the rollers. Cleaning sheet order code: EK50000.
Clearing a jammed pouch
7
• Jamming can occur when laminating unsuitable materials.
CAUTION: To prevent any damages to the laminator, the pouch must
• Move the release lever to the right and pull out the pouch
immediately.
• Clean the rollers after any pouch jam as described in section
“Maintenance and care”.
one minute to cool down.
laminator.
6
• When the POWER/READY LED indicator lights green, insert the
The laminated document automatically exits at the output side.
Inserting the document into the pouch
5
• Insert the document into the laminating pouch. Align it to the
sealed edge as much as possible and maintain even margins left
and right.
Pouches that are too large can be trimmed to size after lamination.
Setting up and switching on the laminator
(1
–
4)
• Set the laminator up on a stable surface (e.g. table) close to a
mains outlet.
item is not blocked and can easily be removed.
• Connect mains cord with mains socket.
• Put the temperature switch in the
position for 75-125 micron
pouches and
for cold pouches.
Instruction Manual
Waste Electrical and Electronic
Equipment (WEEE)
Electrical and electronic devices contain materials and
health and the environment. This symbol indicates that
this device must not be treated as unsorted municipal waste but
must be collected separately. Dispose of the device via a collection
point for the recycling of waste electrical and electronic equipment
within the EU, UK and in other European countries that operate
separate collection systems for waste electrical and electronic
equipment. By disposing of the device in the proper manner, you
help to avoid possible hazards for the environment and public
health that could otherwise be caused by improper treatment of
waste equipment. The recycling of materials contributes to the
conservation of natural resources.
Troubleshooting
Problem Possible cause Solution
Pouch does not
completely seal
the item
Document may be too
thick to laminate
Check the thickness
of the pouch and
the document to be
laminated do not
exceed the max.
throughput thickness
Incorrect pouch
thickness is being used
Check that the pouch
thickness is correct
for the machine and
setting used
Pouch has waves or
bubbles
Incorrect pouch
thickness is being used
Check that the pouch
thickness is correct
for the machine and
setting used
Pouch is lost in the
machine
Pouch is jammed
Operate the manual
reverse lever on the
rear of the machine.
This will separate the
rollers and allow the
pouch to be manually
pulled out by hand
Jamming
Pouch was sealed
Pouch was not centred
on entry
Pouch was not straight
on entry
Empty pouch was used
Thick document or
foreign object was
laminated
Pouch is damaged
after lamination
Damaged rollers or
adhesive on rollers
Pass GBC cleaning
sheets (SKU:
EK50000) through the
machine to test and
clean the rollers
EN
Pouch Description
Machine
Setting
Inspire+
A4
Inspire+
A3
75 micron (2 x 75 micron) 75 micron
100 micron (2 x 100 micron) 100 micron
125 micron (2 x 125 micron) 125 micron
175 micron (2 x 175 micron) 175 micron
250 micron (2 x 250 micron) 250 micron
To Next Page
Loading...
Need help?
General
Weight and Dimensions
